Technogym Group Cycle D92 - Troubleshooting; The Console Does Not Turn on

6.3 TROUBLESHOOTING
6.3.1 THE CONSOLE DOES NOT TURN ON
Possible cause
Components in-
volved
What to do:
The console
does NOT
turn on.
The power supply
(5.5v) does not ar-
rive.
Display faulty.
Generator.
Disconnect the cable that connects the
transformer to the generator from the
transformer. Pedal and check the volt-
age (note 1).
(pin 1 - 2 / pin 1 - 3 / pin 2-3 Vac)
Voltage converter.
Check the 2 Led RPM (blinking yel-
low) and the POWER SUPPLY Led
(xed green).
Check the input voltage to the console
+5.5Vdc.
Display.
If the display must
be replaced, set the
Wi-Fi using the An-
droid APP.
Turn on the console from the PC (it is
OK if the display turns on).
Note: it is also possible to check the sta-
tus of the cable connecting the display
to the transformer; if it is OK, the green
LED on the transformer turns on.
It can be checked if the console is not
functioning by connecting a “power
bank” normally used to recharge cell
phones or a PC with USB - Mini USB
cables.
If the display does not turn on even in
this manner, replace the display.
Cables.
Check the continuity of the positive
and negative pole.
Table 15
At the end of the troubleshooting procedure, test the machine.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 42