Technogym Group Cycle D92 - Configuring Date and Time; Rtc Initialisation; Setting the Date and Time

9.2.5 CONFIGURING DATE AND TIME
9.2.5.1 RTC INITIALISATION
Command Notes
Command @RTCINIT# Initialises the RTC (Real Time Clock).
Table 49
9.2.5.2 SETTING THE DATE AND TIME
Command Notes
Command
@SETDATE dd mm yyyy hh mn

Congures the date and time in the RTC. The pa-
rameters to enter are:
▪ dd: day of the month
▪ mm: month
▪ yyyy: year
▪ hh: hours
▪ mn: minutes
▪ ss: seconds
▪ : time zone; the minutes of devi-
ation from UTC must be entered. If
you are located east of Greenwich,
the value will be positive. Otherwise
it will be negative. As a reference in
Italy when there is Standard Time,
the deviation is +60 minutes, when
it is Daylight Saving Time, it is +120
minutes. If you enter the time, set
UTC to 0.
Table 50
The calibration of the RTC is important for the correct functioning of the Cloud services via TLS/
SSL.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 112