Technogym Group Cycle D92 - Page 119

Figure 90
The following screen appears that requests to select the correct Wa Sensor board installed in the
equipment:
- : old electronics (rev.1);
- : new electronics (rev. 2)
I t is possible to click “”, to have the system automatically
detect the type of board. This is useful if the guards were not removed and the Wa Sensor board
is not visible.
Click Next, to the lower right, to continue.
ATTENTION:selectthecorrectWaSensorboard.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 119