Technogym Group Cycle D92 - Page 125

Figure 99
After pressing Next, the screen “Group Cycle conguration area” appears.
CASE 1: The commands listed below are all active if the database contains the data for this specic
equipment.
• PROGRAM WATT SENSOR BOARD (WRITE SN AND TORQUE TABLE);
• WRITE SERIAL NUMBER;
• WRITE TORQUE TABLE;
• COMPARE BRAKE CALIBRATIONS;
• READ GENERATOR MODEL;
• WRITE GENERATOR MODEL;
• READ TORQUE TABLE.
Figure 100
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 125