Technogym Group Cycle D92 - Page 153

2
Figure 144
2. Remove the pedal crank/pulley assembly
(2) with a pedal crank remover.
3
4
Figure 145
3. Remove the screws (3) and washers with
a 13 mm Allen wrench.
4. Remove the pulley (4).
5. Replace the pedal crank with an original
Technogym part.
Tottherightpedalcrankbackonthebikefollow
the instructions in “11.4.3 Replacing the right and
left pedal crank”.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 153