Technogym Group Cycle D92 - Page 167

3
3
Figure 167
2. Rotate and remove the brake (3).
2
3
4
Figure 168
 Totbackontothebike,leanthebrake(3)
on the spring (4), then shift downwards to
position it.
3. Insert the screw (1) and tighten the nut (2).
Calibrate the brake as indicated in “6.5 Brake
calibration”.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 167