Technogym Group Cycle D92 - Page 7

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 7
6.3.7 PLAYS OF THE HANDLEBAR ASSEMBLY ...................................................... 50
6.3.8 PLAYS OF THE SEAT HORIZONTAL SLIDER ................................................ 53
6.4 GUIDELINE ABOUT THE REPLACING OF THE FLYWHEEL
ALUMINIUM DISC AND BRAKE CALLIPER .......................... 56
6.5 BRAKE CALIBRATION ....................................................................... 56
6.5.1 CHECKING THE ALIGNMENT BETWEEN THE HOLE AND THE TOOTH
OF THE KNOB...............................................................................................................57
6.5.2 CHECKING THE CALIBRATION TEMPLATE .................................................59
6.5.3 MECHANICAL REGULATION OF THE BRAKE POSITION ......................61
6.5.4 SOFT CALIBRATION OF THE BRAKE ................................................................64
6.6 PROCEDURE FOR REPLACING THE WATT SENSOR ID
BOARD ON GROUP CYCLES FIT WITH REV. 2 ELECTRON-
ICS .................................................................................................................. 66
6.7 PROCEDURE TO FOLLOW IF IT IS NECESSARY TO RE-
MOVE THE PLATE ON WHICH THE WATT SENSOR ID IS
FIXED ............................................................................................................ 70
6.8 DIAGNOSTICS OF THE NEW WI-FI/ANT+ CONSOLE VIA THE NRF
CONNECT APP (BLE SIGNAL CHECK) ........................................... 73
6.9 EQUIPMENT TESTING AFTER THE INTERVENTION OF TECHNI-
CAL SERVICE .................................................................................... 80
7. SW UPGRADE .......................................................................................................................... 83
7.1 SW UPGRADE FOR THE OLD WI-FI CONSOLE ..................... 83
7.2 SOFTWARE UPGRADE FOR THE NEW WI-FI / ANT+ CON-
SOLE .............................................................................................................. 84
8. GROUP CYCLE CLASS ........................................................................................................ 87
8.1 REQUIREMENTS FOR CONFIGURING CLASS ..................... 87
8.2 GROUP CYCLE CLASS CONFIGURATION .............................. 87
8.3 CONFIGURING THE GROUP CYCLE APP AS THE MAIN
UNITY SELF APP ................................................................................... 100
8.4 SECOND NETWORK CONFIGURATION ................................ 100
9. EXECUTABLE SW FOR DIAGNOSTICS WITH PC : TERMINAL .................. 103
9.1 ACCESSING THE TERMINAL SW ............................................... 103
9.2 STRUCTURE FOR ENTERING COMMANDS ........................ 104
9.2.1 READING FIRMWARE VERSIONS ....................................................................105
9.2.1.1 (CPU) FIRMWARE VERSION .......................................................................................................105
9.2.1.2 BLE / ANT+ MODULE FIRMWARE VERSION ......................................................................105
9.2.1.3 (WI-FI) FIRMWARE VERSION ..................................................................................................... 105