Tonghui TH2840 Series - Page 155

147
:COMP:TOL:BIN<n><lowA,highA>[…][,lowD,highD]
Parameter:
n ---- Bin number index, the value is 1~10
lowA ---- Represent the floating-point number of low limit of parameter 1
highA ---- Represent the floating-point number of high limit of parameter 1
lowD ---- Represent the floating-point number of low limit of parameter 4
highD ---- Represent the floating-point number of high limit of parameter 4
Example:
:COMP:TOL:BIN11,2 ----Set the upper and lower limits of the first parameter of bin 1 to [1,2];
:COMP:TOL:BIN31,2,3,4 ----Set the upper and lower limits of the first two parameters of bin 3 to
[1,2],[3,4];
:COMP:TOL:BIN101, 2, 3, 4, 5, 6, 7, 8 ---- Set the upper and lower limits of 4 parameters of 10
bins;
:COMP:TOL:BIN1? ---- Returns the upper and lower limits corresponding to the 4 parameters of
bin 1.
9.2.12.5 SEQ:BIN Limit Value
 Description: Set the upper and lower limit data of the continuous mode of the comparison
function (this function is valid when the limit mode is set to continuous mode). You can query
the upper and lower limit values of each bin.
Command systax:
:COMP:SEQ:BIN[A|B|C|D]?
:COMP:SEQ:BIN[A|B|C|D] <lo1>[,hi1,hi2,….hi10]
Parameter:
A|B|C|D ---- Indicate the corresponding number of parameters in the 4 parameters,
lo1 ---- The floating point data of the lower limit of bin 1
hi1…hi10 ---- The floating-point numbers of the upper limit of each bin
Example:
:COMP:SEQ:BIN1,2,3,4,5----Set the first parameter lo1,hi1,hi2,hi3,hi4;
:COMP:SEQ:BINA1,2,3,4,5---- Same as above;
:COMP:SEQ:BINB1,2,3,4,5,6 ----Set the second parameter lo1,hi1,hi2,hi3,hi4,hi5;
:COMP:SEQ:BINC1,2,3,4,5,6,7,8,9,10,11----Set the upper and lower limits of the third parameter
of each bin;
:COMP:SEQ:BIN? ---- Return to the upper and lower limits of parameter 1, bin 1 and the upper
limits of other bins;
:COMP:SEQ:BINA? ---- Same as above
:COMP:SEQ:BINB? ---- Return to the upper and lower limits of parameter 2, bin 1, and the upper
limits of other bins;
:COMP:SEQ:BINC? ---- Return to the upper and lower limits of parameter 3, bin 1 and the upper
limits of otherbins;
:COMP:SEQ:BIND? ---- Return to the upper and lower limits of parameter 4, bin 1 and the upper
limits of other bins.