Tonghui TH2840 Series - Page 159

151
:LIST:CURR? ----Return to the current of all sweep points;
:LIST:CURR4? ----Return to the current of point 4;
9.2.13.7 Bias voltage
 Description: Set the sweep point bias voltage, set the bias voltage of several points starting
from the nth point
Command systax:
:LIST:BIAS:VOLT[n]?
:LIST:BIAS:VOLT[n] <fn>[,fn+1][,fn+2]…
Parameter:
n ---- start from the nth point
fn ---- The floating-point number of swep point n
fn+1 ---- The floating-point number of swep point n+1
fn+2 ---- The floating-point number of swep point n+2
f... ---- The floating-point number of swep point n…
Example:
:LIST:BIAS:VOLT 1,2,3 ----Set the bias voltage of the first 3 points;
:LIST:BIAS:VOLT6 1,2,3,4,5----Set the bias voltage of 6~10 points;
:LIST:BIAS:VOLT? ----Return to the bias voltage of all sweep points;
:LIST:BIAS:VOLT4? ----Return to the bias voltage of point 4;
9.2.13.8 Bias current
 Description: Set the sweep point bias current, set the bias current of several points starting from
the nth point
Command systax:
:LIST:BIAS:CURR[n]?
:LIST:BIAS:CURR[n] <fn>[,fn+1][,fn+2]…
Parameter:
n ---- start from the nth point
f
n
---- The floating-point number of swep point n
f
n+1
---- The floating-point number of swep point n+1
f
n+2
---- The floating-point number of swep point n+2
f... ---- The floating-point number of swep point n…
Example:
:LIST:BIAS:CURR 1m, 2m, 3m ----Set the bias current of the first 3 points;
:LIST:BIAS:CURR6 1m, 2m, 3m, 4m, 5m ---- Set the bias current of 6~10 points;
:LIST:BIAS:CURR? ----Return to the bias current of all points;
:LIST:BIAS:CURR4? ----Return to the bias current of point 4;