Tonghui TH2840 Series - Page 170

162
9.2.17.4 Load type
 Description: It is used to set the measured combination parameter function for load correction
Command systax:
:CURR:TYPE?
:CURR:TYPE <para>
Parameter:
para ---- Indicate the optional function parameter name, the value is as follows:
Example:
:CORR:LOAD:TYPR LSRS ----Set the load type to LS-RS
:CORR:LOAD:TYPR LSQ ----Set the load type to LS-Q
:CORR:LOAD:TYPR CPD ----Set the load type to CP-D
:CORR:LOAD:TYPR? ---- Return to the load type
9.2.17.5 LENGth
 Description: Set the correction cable length of the instrument
Command systax:
:CORR:LENG?
:CORR:LENG <0|1>
Parameter:
0|1|2|4----0m, 1m
Example:
:CORR:LENG 0 ----Set the cable length to 0 meter
:CORR:LENG 1 ----Set the cable length to 1 meter
:CORR:LENG? ----Return to the cable length
9.2.17.6 CLEar
 Description: Clear user correction data
Command systax:
:CORR:CLE [pt]
Parameter:
[pt] ---- means that the parameter can be omitted, the value range of pt is 1~10, indicating the
specified correction point index
Example:
:CORR:CLE ----Clear all user correction data
:CORR:CLE 1 ----Clear the correction data of the first point calibrated by the user
Parameter name
Parameter meaning
LSRS
LS-RS
LSQ
LS-Q
CPD
CP-D