Trunks
318 DID Intercept Assignments
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 6-17
Trunks
05 Audio Day1 Dst Type
06 Audio Day2 Dst Type
07 Audio Night Dst Type
Select the Audio/Speech call Day1 destination type.
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or
Night Bell
• No Data – no destination will ring when the line rings into the system.
• Dialing Digits – assigns the line to ring the directory number or access code
defined in the “Destination Digits” assignment
• DSIA – assigns the line to ring in as a DSIA call. DSIA dial tone will be
returned to the caller.
• Modem – assigns the line to ring the remote maintenance modem on the
CTX processor. Used to call into the system with a CTX WinAdmin PC and
modem.
• Night Bell – Assigns the line to cause the night relay to pulse (one-
sec.close/3-sec.open)
Audio Day1 Dst. DN
Audio Day2 Dst DN
Audio Night Dst DN
Enter the Destination Directory Number. Destination DN is only required if the
destination type is “Dialing Digits”
Possible values: Up to 32 ASCII characters (default = no value)
08 Data Day1 Dst Type
09 Data Day2 Dst Type
10 Data Night Dst Type
Select the data call Day1 destination type
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or
Night Bell
• No Data – no destination will ring when the line rings into the system.
• Dialing Digits – assigns the line to ring the directory number or access code
defined in the “Destination Digits” assignment
• DSIA – assigns the line to ring in as a DSIA call. DSIA dial tone will be
returned to the caller.
• Modem – assigns the line to ring the remote maintenance modem on the
CTX processor. Used to call into the system with a CTX WinAdmin PC and
modem.
• Night Bell – Assigns the line to cause the night relay to pulse (one-
sec.close/3-sec.open)
Data Day1 Dst DN
Data Day2 Dst DN
Data Night Dst DN
Enter the Destination Directory Number. Destination DN is only required if the
destination type is “Dialing Digits”
Possible values: Up to 32 ASCII characters (default = no value)
FIELD DESCRIPTION
To Next Page
Loading...
