System Error Codes
Station Programming Error Codes
B-8 Strata CTX Programming - Part 4: Appendices 04/03
213
51
)%
120
130
When setting an owner extension to the additional information
of CO, GCO, the said CO, GCO keys are not assigned to the
Feature Buttons of the owner extension.
52 -
The Primary DN entered conflicts with an existing DKT
extension.
52
)%
110
The secondary/PhDN entered cannot be registered. The
number conflicts with an existing ISDN extension(s), etc.
52
)%
120
130
The CO or GCO Owner DN entered does not exist.
80
)%
The specified Prime DN does not exist in the system.
82
The additional information assigned to the Feature Button is
invalid.
82 - 120 The line number entered does not exist.
96
110
130
140
The allowable number of GCO, POOL or PhDn has been
exceeded.
98 -
The quantity of Flexible buttons programmed exceeds the
system’s capacity.
214
33
)%a)%
The equipment number entered is out of the range.
49
The designated circuit is already in use.
50
Multiple DSSs cannot be assigned to the same Shelf/Slot/
Circuit.
51
The entered DN does not exist in the system (the entered
value conflicts with an existing extension number or
numbering plan).
52
The entered value conflicts with an existing numbering plan.
80
)%
The designated Prime DN does not exist in the system.
80
)%a)%
The designated PCB and extension combination is not
allowed.
96
)%a)%
The number of DSS consoles entered exceeds the system’s
capacity.
98
The number of DSS buttons entered exceeds the system’s
capacity. This error can occur with PB1~PB8
Program Code FB
Sub-
parameter
Error Descriptions
To Next Page
Loading...
