Trimble GCS900 - Using 3 D Guidance in the Field

5Using 3D Guidance in the Field
In this chapter:
n Introduction
n Preparing 3D sensors
n Checking 3D cutting edge
guidance
n Loading or creating a design
n Lane guidance
n Working with 3D guidance
This chapter describes how to set up 3D
guidance systems and use them in the field.
For more information about 3D guidance
systems and their sensors, refer to the GCS900
Grade Control System Reference Manual.
GCS900 Grade Control System for Excavators Operator's Manual 107
C H A P T E R
5