Trimble GCS900 - Other selected error messages

7 Troubleshooting intheField
When a design with a site-wide or design specific avoidance zone:
l Is unloaded.
one of the following full-screen warning messages appear:
l
A site-wide avoidance file is no longer being used. Press \ to continue.
or
l
A design specific avoidance file is no longer being used. Press \ to
continue.
Note – These messages are displayed as warnings for the operator.
7.5.3 Other selected error messages
A system error has occurred. The application has been shut down for safety.
On start-up, one or more of the system’s software components failed to start.
Contact your site supervisor.
AS400 …
The AS400 has reported a fault. Faults may occur while the AS400 updates its
settings during, or immediately after, a firmware update or pitch calibration.
Try one of the following actions:
l Wait two minutes for the settings to take effect.
l Check all cable connections.
l To check that all devices are responding, use the procedure in 7.3 Running
system diagnostics.
If problems persist, contact your dealer.
172 GCS900 GradeControl System for Excavators Operator's Manual