7 Troubleshooting intheField
System Startup Error
On start-up, one or more of the system’s software components failed to start.
Contact your site supervisor.
The design cannot be loaded. It uses a CAL file to define the coordinate system and this
is not compatible with MS990 receivers.
The coordinate system specified by the *.cal file in the design folder is not
supported by the GNSSreceivers on the machine.
Contact your site supervisor to install an MS9x2 GNSS receiver with the correct
firmware, or to add a *.cfg file to the design folder.
The design cannot be loaded because it requires a <coordinate system> file which is
missing. The design will be unloaded.
The *.cfg file in the design folder does not contain a coordinate system file, or the
*.cal file in the design folder requires a coordinate system file that cannot be found
in the \GeoData folder.
Contact your site supervisor to add the required coordinate system file to the *.cfg
file, or the required coordinate system file and/or coordinate adjustment file to the
\GeoData folder.
The design contains more than one receiver configuration file and cannot be loaded. The
design will be unloaded.
Two or more *.cfg files and/or *.cal files are present in the design folder being
loaded. Adesign folder may only contain one *.cfg file and/or one *.cal file.
Contact your site supervisor to remove the incorrect files.
The GNSS receivers do not recognize the antenna type being transmitted by the base
station
The on-machine GNSS receiver(s) do not recognize the base station antenna type,
and are unable to correct for the elevation difference between the antenna reference
point and the antenna phase center.
Contact your site supervisor.
The Machine name has not been set
Machines are given names at the time of installation. If you restore a machine
settings file from version 10.80 or earlier onto a later system, this message is
176 GCS900 GradeControl System for Excavators Operator's Manual
To Next Page
Loading...
