7 Troubleshooting intheField
The selected lane cannot be used with the master alignment of this design.
Select a lane within the range of the master alignment or do not use lane guidance
on this section of the design.
Press \ to continue.
The selected lane cannot be used with the current master alignment of this design.
Select a lane within the range of the master alignment, select a different master
alignment or do not use lane guidance on this section of the design.
Press \ to continue.
No lane can be defined.
Please choose a different lane or do not use lane guidance for this part of the
design.
Press \ to continue.
Your chosen lane cannot be used with the master alignment of this design.
Either choose lane sides that are within range of your master alignment or do not
use lane guidance on this section of the design.
Press \ to continue.
There is no master alignment in the design.
A master alignment is required for lane guidance. A line in the design may be
selected as the master alignment.
The master alignment should be approximately parallel to the required lane.
Press \ to select a master alignment for this design.
Press = to cancel.
The lane cannot be defined.
Lane width must be greater than 0.3 m.
Select a different lane or do not use lane guidance on this section of the design.
Press \ to continue.
178 GCS900 GradeControl System for Excavators Operator's Manual
To Next Page
Loading...
