18.THE LIST OF INITIAL SETTING VALUE
176
18. THE LIST OF INITIAL SETTING VALUE
* Initial value : Factory-shipped values.
* LOCK 1 : Changing of setting values is inhibited by the software switch (Setting Value
LOCK in setting mode 4) (stored in the SRAM).
* LOCK 2 : Changing of setting values is inhibited by the software switch (Setting Value
LOCK in setting mode 4) (stored in the NOV RAM).
* LOCK SW : Changing of setting values is inhibited by the LOCK switch on the rear panel
(stored in the NOV RAM).
* Display : Setting cannot be changed.
18-1. Setting Mode 0
18-2. Setting Mode 1
Setting item
Initial
value
LOCK 1
(SRAM)
LOCK 2
(NOV.RAM)
LOCK SW
(NOV.RAM)
Display
1 Upper Limit 000.00
◎
2 Lower Limit 000.00
◎
3 Near Zero 000.00
◎
4 Set Point 1 000.00
◎
5 Set Point 2 000.00
◎
6 Compensation 00.00
◎
7Over 0.00
◎
8 Under 0.00
◎
9 Final 000.00
◎
→→→
F
CNG/ENT CNG/ENT
1
UPPER
Setting item
Initial
value
LOCK 1
(SRAM)
LOCK 2
(NOV.RAM)
LOCK SW
(NOV.RAM)
Display
1 Comparison Inhibit Time 0.50
◎
2 Judging Time 1.50
◎
3 Complete Output Time 3.00
◎
4 Adjust Feeding Time 1.00
◎
5Auto Zero Times 01
◎
6 Judging Times 01
◎
7
Auto Free Fall Compensation
Regulation
098.00
◎
8 Analog Filter 2
◎
9 Tare Weight 000.00
◎
To Next Page
Loading...
