Unipulse F701-C

3.METHODS OF SETTING
26
3-2-2. Setting Mode 1
In setting mode 1, output signals for final discharging control and parameters in sequence mode,
etc., are to be set.
- Comparison Inhibit Time
(For details, please refer to "6-8" on P.93.)
- Judging Time
(For details, please refer to "6-8" on P.93.)
- Complete Output Time
(For details, please refer to "6-8" on P.93.)
- Adjust Feeding Time (Effective when selecting sequence mode)
(For details, please refer to "6-9" on P.96.)
- Auto Zero Times (Effective when selecting sequence mode)
(For details, please refer to "6-9" on P.96.)
- Judging Times (Effective when selecting sequence mode)
(For details, please refer to "6-9" on P.96.)
．
sec. (0.00 ~ 9.99)
1
UPPER
．
sec. (0.00 ~ 9.99)
2
LOWER
．
sec. (0.00 ~ 9.99)
3
NEAR Z .
．
sec. (0.00 ~ 9.99)
4
SP1
(0 ~ 99)
5
SP2
(0 ~ 99)
6
CPS