Unipulse F701-C

3.METHODS OF SETTING
31
3-2-4. Setting Mode 3
In setting mode 3, setting values relating to initial calibration are to be set.
- Balance Weight Value
(For details, please refer to "4-4-6" on P.48.)
- Capacity
(For details, please refer to "4-4-4" on P.47.)
- Min. Scale Division
(For details, please refer to "4-4-5" on P.47.)
- Net Over
(For details, please refer to "6-10" on P.100.)
- Gross Over
(For details, please refer to "6-10" on P.100.)
- DZ Regulation Value
(For details, please refer to "5-10" on P.62.)
(0 ~ 99999)
1
UPPER
(0 ~ 99999)
2
LOWER
(1 ~ 100)
3
NEAR Z .
(0 ~ 99999)
4
SP1
(0 ~ 99999)
5
SP2
(0 ~ 9999)
6
CPS