6.DISCHARGING CONTROL MODE
75
6-1-3. Discharging Mode
Set the feeding or discharging. Selectable methods are feeding control, discharging control and
external selection (Changing the feed/Discharge by the signal from control connector).
1) Select setting mode 2.
2) Select Discharging control mode. (1-Weighing Function 1)
- Discharging control mode by external signal
Switch with the pin set at “Feed/Discharge” out of B2 to B5 pin on the control connector.
OFF → Feeding control, ON → Discharging control.
→→→
F
CNG/ENT CNG/ENT
2
LOWER
Discharging control mode
2 : External selection
1 : Discharging control
0 : Feeding control
→→→
1
UPPER
CNG/ENT CNG/ENT
OFF
ON
Undecided interval (within 50ms)
Discharging control
Feeding control
To Next Page
Loading...
