1.APPEARANCE DESCRIPTION
4
ZERO - Lights at a true zero point (0±1/4 scale division).
(When the 1/4 scale division display is OFF under
Function Selection in setting mode 3.)
- Lights at a true zero point (0±1/4 scale division),
and at the central point of the scale interval of the indicated
value (indicated value ±1/4 × Min. Scale Division).
(When the 1/4 scale division display is ON under
Function Selection in setting mode 3.)
Flashes when the voltage of the lithium battery for memory backup has
dropped.Replace with a new battery.
For the method of replacement, refer to "13.REPLACEMENT OF THE BACKUP
BATTERY" on P.166.
* The expression “ ” in this instruction manual shows that 「」 on the status display lights,
goes out, or flashes.
⑤ Setting keys
When the key is pressed, the Tare weight is displayed, and
“” flashes.
(When the Tare weight display with the key is valid under
Restriction on the Tare Subtraction Function in setting mode 4.)
To go back to the weight display, press the key again.
Numerical keys to make settings.
Function key to switch the setting mode.
Change/Enter key to confirm setting items and setting values.
⑥ Function keys
Key to perform one-touch Tare subtraction.
“ ” on the status display lights. (In setting mode 0)
However, Tare subtraction is performed only in the following cases
depending on the setting of Restriction on the Tare Subtraction Function
in setting mode 4.
- When the weight value is stable (when “ ” is on).
- When the range of Tare subtraction is 0 ＜ Tare ≦ Capacity.
Use as an increment key for setting operation.
Key to reset Tare subtraction. (In setting mode 0)
However, the Tare Weight is not cancelled.
Use as a decrement key for setting operation.
To Next Page
Loading...
Need help?
General
