29
TECHNICAL MANUAL
99P
cal 5ave
{}ait 0
0
Z
KEY FUNCTIONS IN CALIBRATION MODE
Cycles the display between Graduated Counts (Displayed weight
prefixed by a blinking letter “C”) and Raw Internal Counts (Prefixed
by a blinking letter “a”).
Continues to function as in normal Weighing Mode.
Confirms entry of new Parameter Values (in certain cases only).
Select Parameters and confirms entry of most Parameter Values.
Aborts any parameter change without saving.
Used to increase some parameter values. Specific Parameter
Descriptions will address the exact function of this key.
Used to decrease some parameter values. Specific Parameter
Descriptions will address the exact function of this key.
EXIT CALIBRATION MODE - PARAMETER 99
Description: Exits Calibration Mode and restarts the M2000. All
calibration changes are saved to flash memory and the
Audit Trail is updated.
1. Enter 99 followed by the [PRINT/SELECT] key.
2. The display will flash, run through a save series, and return to
Normal Weighing Mode.
O
T
.
0
C
P
To Next Page
Loading...
