Western Scale M2000 - Keypress Feedback; Lock Measuring Units (Example)

49
TECHNICAL MANUAL
105P
1P
6P
1
0P
KEYPRESS FEEDBACK - PARAMETER 29
Description: This function will cause the display to blink every time a key
is pressed. This gives the User a sense of feedback,
especially in noisy environments where hearing the key
beeps may be difficult.
PARAMETER VALUE KEYPRESS FEEDBACK
0 (default) OFF
1 ON
LOCK UNITS - PARAMETER 105
Description: Prevents the user from switching the measuring units.
Used in conjunction with Parameter 6 – Power On Units.
Use Parameter 6 (See Page 46) to select the desired units,
then use Parameter 105 to lock the M2000 on those units.
PARAMETER VALUE MEASUREMENT UNITS
0 (default)
Not Locked
1
Locked
EXAMPLE: LOCK UNITS ON lbs.
1. Enter Parameter 6 and select 0 for “lbs”.
2. Select Parameter 105.
3. Press 1 followed by the [PRINT/SELECT] key to lock the units.