WTI TSM Series - 7 Alarm Configuration

7-1
7. Alarm Configuration
When properly configured, the TSM/RSM can monitor temperature readings, ping
command response and a number of other factors at network installation sites and
log this information for future review. When any monitored condition exceeds user-
defined trigger levels, the TSM/RSM can also notify support personnel via Email, Syslog
Message or SNMP trap. In addition to the monitoring and notification capabilities
provided by standard TSM/RSM series units, RSM-8R8-CM series units can also
measure and record current, power and voltage conditions at each power outlet.
Notes:
• CurrentandPowerMonitoringfeaturesarenotavailableonstandardTSM
unitsorstandardRSMunits.
• Inordertosendalarmnotificationviaemail,emailaddressesandparameters
mustfirstbedefinedasdescribedinSection5.9.11.Emailalarmnotification
willthenbesentforallalarmsthatareenabledasdescribedinthisSection.
• InordertosendalarmnotificationviaSyslogMessage,aSyslogaddress
mustfirstbedefinedasdescribedinSection5.9.2.OncetheSyslogaddress
hasbeendefined,SyslogMessageswillbesentforeveryalarmthatis
discussedinthisSection,providingthattheTriggerEnableparameterforthe
alarmhasbeensetto"On."
• InordertosendalarmnotificationviaSNMPTrap,SNMPTrapparameters
mustfirstbedefinedasdescribedinSection5.9.7.OnceSNMPTrap
Parametershavebeendefined,SNMPTrapswillbesentforeveryalarmthat
isdiscussedinthisSection,providingthattheTriggerEnableparameterfor
thealarmhasbeensetto"On."
• AfterdefiningparametersviatheTextInterface,makecertaintopressthe
[Esc]keyseveraltimestocompletelyexitfromtheconfigurationmenu
andsavenewlydefinedparameters.Whenparametersaredefinedviathe
TextInterface,newlydefinedparameterswillnotbesaveduntilthe"Saving
Configuration"messageisdisplayed.
To configure the TSM/RSM's Alarm functions, access the command mode using a
password that allows Administrator level and then activate the Alarm Configuration
menu (in the Text Interface, type /AC and press [Enter]; in the Web Browser Interface,
click on the "Alarm Configuration" link.)