5-4
Basic Configuration
5.2. Configuration Menus
Although the Web Browser Interface and Text Interface (Command Line Interface)
provide two separate means for selecting parameters, both interfaces allow access to
the same set of basic parameters, and parameters selected via one interface will also be
applied to the other. To access the configuration menus, proceed as follows:
• TextInterface: Refer to the Help Screen (/H) and then enter the appropriate
command to access the desired menu. When the configuration menu appears, key
in the number for the parameter you wish to define, and follow the instructions in
the resulting submenu.
• WebBrowserInterface: Use the links and fly-out menus on the left hand of the
screen to access the desired configuration menu. To change parameters, click in
the desired field and key in the new value or select a value from a pull-down menu.
To apply newly selected parameters, click on the "Change Parameters" button at the
bottom of the menu or the "Set" button next to the field.
The following sections describe options and parameters that can be accessed via each
of the configuration menus. Please note that essentially the same set of parameters and
options are available to both the Web Browser Interface and Text Interface.
Notes:
• Configurationmenusareonlyavailablewhenyouhaveloggedintocommand
modeusingapasswordthatpermitsAdministratorLevelcommands.
SuperUseraccountsareabletoviewconfigurationmenus,butarenot
allowedtochangeparameters.
• Configurationmenusarenotavailablewhenyouarecommunicatingwiththe
TSM/RSMviaPDA
• WhendefiningparametersviatheTextInterface,makecertaintopressthe
[Esc]keyseveraltimestocompletelyexitfromtheconfigurationmenu
andsavenewlydefinedparameters.Whenparametersaredefinedviathe
TextInterface,newlydefinedparameterswillnotbesaveduntilthe"Saving
Configuration"messagehasbeendisplayedandthecursorreturnstothe
commandprompt.
To Next Page
Loading...
Need help?
General
