WTI TSM Series User Manual

5-46
Basic Configuration
5.9.1. Network Port Parameters
In the Text Interface, these parameters are found in the main Network Configuration
menu In the Web Browser Interface, these parameters are found by placing the cursor
over the "Network Configuration" link on the left hand side of the screen, and then
clicking on the "Network Port Parameters" link in the resulting fly-out menu.
• AdministratorMode: Permits/denies port access to accounts that allow
Administrator level commands. When enabled (Permit), the port will be allowed
to invoke Administrator level commands, providing they are issued by an account
that permits them. If disabled (Deny), then accounts that permit Administrator level
commands will not be allowed to access command mode via this port.
(Default = Permit)
• LogoffCharacter: Defines the Logoff Character for the network port. This
determines which command(s) must be issued at this port in order to disconnect
from a second port. (Default = ^X ([Ctrl] plus [X]))
Note:TheSequenceDisconnectparametercanbeusedtopickaone
characterorathreecharacterlogoffsequence.
• SequenceDisconnect: Enables/Disables and configures the Resident Disconnect
command. Offers the option to either disable the Sequence Disconnect, or select a
one character, or three character command format. (Default = One Character).
Notes:
• TheOneCharacterDisconnectisintendedforsituationswherethe
destinationportshouldnotreceivethedisconnectcommand.Whenthe
ThreeCharacterformatisselected,thedisconnectsequencewillpass
throughtothedestinationportpriortobreakingtheconnection.
• WhenThreeCharacterformatisselected,theResidentDisconnectusesthe
format"[Enter]LLL[Enter]",whereListheselectedLogoffCharacter.
• InactivityTimeout: Enables and selects the Inactivity Timeout period for the
Network Port. If enabled, and the port does not receive or transmit data for the
specified time period, the port will disconnect. (Default = 5 Minutes)
• CommandEcho: Enables or Disables the command echo for the Network Port.
(Default = On).
• AcceptBreak: Determines whether the port will accept breaks received from the
attached device, and pass them along to a connected port. When enabled, breaks
received at this port will be passed to any port this port is connected to, and sent
to the device connected to the other port. When disabled, breaks will be refused at
this port. (Default = On)
• MultipleLogins: (Text Interface Only) If the TSM/RSM is installed in an
environment thatdoesnot include communication via an open network (local
communication only), then the Multiple Logins parameter can be used to determine
whether or not multiple users will be able to communicate with the unit at the
same time. If this parameter is set to "Off" then only one user will be allowed to
communicate with the unit at a time. (Default = On)

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English