10-8
Telnet & SSH Functions
10.5. Creating an Outbound Telnet Connection
The TSM/RSM includes a /TELNET command, that can be used to create an outbound
Telnet connection. In order to use the /TELNET command, you must access the
TSM/RSM's Text Interface command mode using an account that permits Telnet Access
and Outbound Access, via one of the TSM/RSM's Serial RS232 Ports as
described below.
Notes:
• Inorderforthe/TELNETcommandtofunction,TelnetAccessandOutbound
ServiceAccessmustbeenabledforyouruseraccountasdescribedin
Section5.5.
• The/TELNETcommandisonlyavailableviatheTextInterface.
• IfyouhaveloggedinviatheNetworkPort,the/TELNETcommandwillnot
function.
To create an outbound Telnet connection, access the Text Interface via a free Serial Port,
using an account that permits Telnet Access and Outbound Access and then invoke the
/TELNET command using the following format:
/TELNET <ip> [port] [raw] [Enter]
Where:
ip Is the target IP address.
port Is an optional argument which can be included to indicate the target port
at the IP address.
raw Is an optional argument which can be included to indicate a raw socket
connection. In order to create a raw socket connection, the command line
must end with the text "raw".
For example, to create a raw socket, outbound Telnet connection to port 2000 at IP
Address 255.255.255.255, access the Text Interface command mode via a free
TSM/RSM Serial Port using an account that permits Telnet Access and Outbound
Access and invoke the TELNET command as follows:
/TELNET 255.255.255.255 2000 raw [Enter]
To Next Page
Loading...
Need help?
General
