WTI TSM Series - Dictionary Support for RADIUS

5-67
Basic Configuration
• AccountingPort: The Accounting Port number for the RADIUS function.
(Default = 1813)
• Debug: (Text Interface Only) When enabled, the TSM/RSM will put RADIUS debug
information into Syslog. (Default = Off)
• OneTimeAuth: This feature should be enabled when using Two Factor
Authentication with the One Time Password scheme enabled. When enabled, the
One Time Password will be valid for the time specified under the OneTime Auth
Timer parameter. (Default = Off)
• OneTimeAuthTimer: When the OneTime Auth parameter is enabled, this
parameter determines how long (in minutes) the One Time Password will be valid.
(Default = 5 Minutes)
• PingTest(PingRADIUSServers): Allows you to ping IP addresses or domain
names that have been defined via the RADIUS Parameters menus in order to check
that a valid IP address or domain name has been entered.
Notes:
• InorderforthePingTestfeaturetofunction,yournetworkand/orfirewall
mustbeconfiguredtoallowpingcommands.
• InadditiontothePingTestfeature,the/TESTcommandintheTextInterface
orthe"Test"optionintheWebBrowserInterfacecanalsobeusedtoping
anyuserdefinedIPaddressinordertomakecertainthattheIPaddressis
responding.
5.9.10.1. DictionarySupportforRADIUS
The RADIUS dictionary file can allow you to define a user and assign command access
rights and port access rights from a central location.
The RADIUS dictionary file, "dictionary.wti" is included on the CDROM along with this
user's guide. To install the dictionary file on your RADIUS server, please refer to the
documentation provided with your server; some servers will require the dictionary file
to reside in a specific directory location, others will require the dictionary file to be
appended to an existing RADIUS dictionary file.
The WTI RADIUS dictionary file provides the following commands:
• WTI-Super - Sets the command access level for the user. This command provides
the following arguments:
0 = ViewOnly
1 = User
2 = SuperUser
3 = Administrator
For example, in order to set command access level to "SuperUser", the command
line would be:
WTI-Super="2"