4-1
4. Hardware Installation
4.1. Connecting the Power Supply Cables
4.1.1. Connect the TSM/RSM to Your Power Supply
Refer to the cautions listed below and at the beginning of this User's Guide, and then
connect the TSM/RSM unit to an appropriate power supply.
CAUTIONS:
• Before attempting to install this unit, please review the warnings and
cautions listed at the front of the user’s guide.
• This device should only be operated with the type of power source
indicated on the instrument nameplate. If you are not sure of the type of
power service available, please contact your local power company.
• Reliable earthing (grounding) of this unit must be maintained. Particular
attention should be given to supply connections when connecting to
power strips, rather than directly to the branch circuit.
4.1.2. Installing the Power Supply Cable Keeper
The TSM/RSM includes a cable keeper, which is designed to prevent the AC power
supply cable from being accidentally disconnected from the unit.
When attaching the power supply cable to the unit, first swing the cable keeper out of
the way, then plug the power cable securely into the power input. When the cable is in
place, snap the cable keeper over the plug to secure the cable to the unit.
To Next Page
Loading...
Need help?
General
