To Next Page

To Previous Page

5-30

Basic Configuration

5.7. Defining Plug Parameters - (RSM-8R8 Series Units Only)

The Plug Parameters Menu is used to define Plug Names, boot/sequence delay times

and Power Up Default values for each of the TSM/RSM's Switched AC Outlets. Note

that this function is only available when you have accessed command mode using a

password that permits Administrator Level commands.

To define Plug Parameters via the Text Interface, type /PL and then press [Enter] to

display the Plug Parameters Menu. To define plug parameters via the Web Browser

Interface, click on the Plug Parameters link on the left hand side of the screen to display

the Plug Parameters Menu.

The Plug Parameters Menu allows you to define the following parameters:

Note: PowercontrolfunctionsareonlyavailableonRSM-8R8Seriesunits.

ThePlugParametersMenuisnotpresentonstandardTSMSeriesunitsor

standardRSMSeriesunits.

• PlugName: Up to 16 Characters. (Defaults for Plugs 1 through 8 = Outlet1 -

Outlet8)

Note: PlugNamescannotbeginwithanumber,dash(-),underscore

character(_),forwardslashcharacter(/)orbackslashcharacter(\),and

cannotincludenonprintablecharacters,spaces,asterisks(*),colons(:),the

plussymbol(+)orquotationmarks.

• Boot/Seq.Delay: When more than one plug is switched On or a reboot cycle is

initiated, the Boot/Sequence delay determines how much time will elapse before

the next plug is switched On. When the Boot/Sequence Delay is applied, the

TSM/RSM will wait for the user-defined delay period before switching On the next

plug. This allows time for the device connected to the first plug to adequately

"wake up" before switching on power to the device connected to the next plug.

When Reboot cycles and switching actions are initiated, the Boot/Sequence Delay

will be applied as follows: (Default = 0.5 Second)



RebootCycleDelay: During a reboot cycle, the TSM/RSM will first switch all

selected plugs "Off" (with a 0.5 second pause between each "Off" operation), and

then begin to switch selected plugs back On again, pausing for the user-defined

Boot/Sequence Delay before switching On the next plug. For example, if the

Boot/Sequence Delay for Plug 3 is ten seconds, then the TSM/RSM will pause for

ten seconds before proceeding to the next plug.



"On"SequenceDelay: When two or more plugs are switched On, the TSM/RSM

will pause for the user-defined Boot/Sequence Delay before switching On the

next plug.

WTI TSM Series User Manual

Questions and Answers: