To Next Page

To Previous Page

5-61

Basic Configuration

• Debug: This option is used to assist WTI Technical Support personnel with the

diagnosis of LDAP issues. (Default = Off)

• PingTest: Allows you to ping IP addresses or domain names that have been

defined via the LDAP Parameters menus in order to check that a valid IP address or

domain name has been entered.

Notes:

• InorderforthePingTestfeaturetofunction,yournetworkand/orfirewall

mustbeconfiguredtoallowpingcommands.

• InadditiontothePingTestfeature,the/TESTcommandintheTextInterface

orthe"Test"optionintheWebBrowserInterfacecanalsobeusedtoping

anyuserdefinedIPaddressinordertomakecertainthattheIPaddressis

responding.

5.9.8.1. AddingLDAPGroups

Once you have defined several users and passwords via your LDAP server, and

assigned those users to LDAP Groups, you must then grant command and port access

rights to each LDAP Group at each individual TSM/RSM unit.

To add LDAP groups to your TSM/RSM unit, log in to the command mode using a

password that permits access to Administrator level commands. The Add LDAP Group

menu allows the following parameters to be defined:

• GroupName: Note that this name must match the LDAP Group names that you

have assigned to users at your LDAP server. (Default = undefined)

• AccessLevel: Sets the command access level to either Administrator, SuperUser,

User or ViewOnly. For more information, please refer to Section 5.4.1.

(Default = User)

• PortAccess: This item is used to select the serial ports that members of this LDAP

group will be allowed to connect. (Default = undefined)

Note:WhenconfiguringaTSM/RSMunitthatincludesaninternalmodem,the

PortAccessparameterisalsousedtograntordenyuseraccesstotheinternal

modemport.On8-portTSM/RSMunits,port9istheinternalmodemport;on

16-portRSMunits,port17istheinternalmodemport;on24-portTSMunits,

port25istheinternalmodemport;on40-portTSMunits,port41istheinternal

modemport.TheinternalmodemisnotincludedonTSM/RSMmodelnumbers

thatendwiththe"NMI"suffix.

• PlugAccess: (RSM-8R8 Series Units Only) This item is used to determine which

plugs members of this group will be allowed to control. (Default = undefined)

Note:PowerControlfunctionsareonlyavailableonRSM-8R8Seriesunits.

ThePlugAccessparameterandPlugGroupAccessparameterarenotavailable

onstandardTSMSeriesunitsorstandardRSMSeriesunits.

WTI TSM Series User Manual

Questions and Answers: