To Next Page

To Previous Page

5-60

Basic Configuration

• LDAPPort: Defines the port that will be used to communicate with the LDAP

server. (Default = 389)

• TLS/SSL: Enables/Disables TLS/SSL encryption. Note that when TLS/SSL

encryption is enabled, the LDAP Port should be set to 636. (Default = Off)

• BindType: Sets the LDAP bind request password type. Note that in the Text

Interface, when the Bind Type is set to "Kerberos" LDAP, the menu will include

additional prompts used to select Kerberos parameters. (Default = Simple)

• SearchBindDN: Selects the user name who is allowed to search the LDAP

directory. (Default = undefined)

• SearchBindPassword: Sets the Password for the user who is allowed to search

the LDAP directory. (Default = undefined)

• UserSearchBaseDN: Sets the directory location for user searches.

(Default = undefined)

• UserSearchFilter: Selects the attribute that lists the user name. Note that this

attribute should always end with "=%S" (no quotes.) (Default = undefined)

• GroupMembershipAttribute: Selects the attribute that list group membership(s).

(Default = undefined)

• GroupMembershipValueType: (Default = DN)

• Fallback: Enables/Disables the LDAP fallback feature. When enabled, the

TSM/RSM will revert to it's own internal user directory if no defined users are

found via the LDAP server. In this case, port access rights will then be granted as

specified in the default LDAP group. (Default = Off)

• KerberosSetup: Kerberos is a network authentication protocol, which provides

a secure means of identity verification for users who are communicating via a

non-secure network. In the Text Interface, Kerberos parameters are selected via a

submenu that is only available when Kerberos is selected as Bind Type. In the Web

Browser Interface, Kerberos parameters are defined via the main LDAP Parameters

menu. The following parameters are available:



Port: (Default = 88)



Realm: (Default = Undefined)



KeyDistributionCenters(KDC1throughKDC5): (Default = Undefined)



DomainRealms1through5: (Default = Undefined)

• LDAPGroupSetup: Provides access to a submenu, which is used to define LDAP

Groups as described in the Sections 5.9.8.1 through 5.9.8.4.

WTI TSM Series User Manual

Questions and Answers: