WTI TSM Series User Manual

5-36
Basic Configuration
5.8.2. The Serial Port Configuration Menu
To configure the TSM/RSM's Serial Ports via the Text Interface, type /P n and then press
[Enter] (Where n is the name or number of the desired port. To configure the Serial
Ports via the Web Browser Interface, click the "Serial Port Configuration" link on the left
hand of the screen and then use the dropdown menu to select the desired port.
The Serial Port Configuration menu allows the following parameters to be defined. Note
that all of these parameters are available via both the Text Interface and Web Browser
Interface, and that parameters selected via one interface are also applied to the other.
CommunicationSettings:
• BaudRate: Any standard rate from 300 bps to 115.2K bps. (Defaults; Serial Ports
1 to 8 = 9600 bps; Internal Modem Port = 57.6K bps)
• Bits/Parity: (Default = 8-None)
• StopBits: (Default = 1)
• HandshakeMode: XON/XOFF, RTS/CTS (hardware), Both, or None.
(Default = RTS/CTS)
GeneralParameters:
• AdministratorMode: Permits/denies port access to Administrator level accounts.
When enabled (Permit), the port will be allowed to invoke Administrator level
commands, providing they are issued by an account that permits them. If disabled
(Deny), then accounts that permit Administrator level commands will not be allowed
to access command mode via this port. (Default = Permit)
Note:AdministratorModecannotbedisabledatSerialPort1(theSetUpport.)
• LogoffCharacter: The Logoff Character determines the command(s) or
character(s) that must be issued at this port in order to disconnect. Note that the
Logoff Character does not apply to Direct Connections. (Default = ^X)
• SequenceDisconnect: Enables/Disables and configures the Resident Disconnect
command. This offers the option to disable the Sequence Disconnect, select a one
character format or a three character format. (Default = One Character)
• InactivityTimeout: Enables and selects the Timeout Period for this port. If
enabled, the Serial Port will disconnect when no additional data activity is detected
for the duration of the timeout period. (Default = 5 Minutes)
Notes:
• WhentheInactivityTimeoutisdisabled,thisallowsportstoautomatically
reconnectafterapowerinterruption.Whenpowerisrestored,pairsofports
thatwerepreviouslyconnectedwillbeautomaticallyreconnected,providing
thattheInactivityTimeoutisdisabledatbothports,andthetwoportshave
beenconnectedforatleasttenminutespriortothepowerinterruption.
• TheonlyexceptiontothisruleisSerialPort1,whichwillremain
disconnectedafterpowerisrestoredinordertoprovideafreeserialportfor
localaccesstocommandmode.

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English