To Next Page

To Previous Page

9-13

Operation

9.2.2. The Plug Group Control Screen - Web Browser Interface

Note:PowerswitchingandrebootfunctionsareonlyavailableonRSM-8R8

Seriesunits.StandardTSMSeriesunitsandRSMSeriesunitsdonotsupport

powercontrolfunctions.

The Plug Group Control Screen is used to send switching and reboot commands to

the user-defined Plug Groups. As described in Section 5.6, Plug Groups allow you to

specify a group of outlets that are dedicated to a similar purpose or client, and then

direct switching commands to the group, rather than switching one plug at a time.

To apply power switching commands to Plug Groups, first access command mode via

the Web Browser Interface (see Section 5.1.) Click on the "Plug Group Control" link on

the left hand side of the screen to display the Plug Group Control Screen. When the

Plug Group Control Screen appears, click the down arrow in the "Action" column for

the desired Plug Group(s), then select the desired switching option from the dropdown

menu and click on the "Confirm Plug Actions" button

When the "Confirm Plug Group Actions" button is pressed, the RSM-8R8 Series unit

will display a screen which lists the selected action(s) and asks for confirmation before

proceeding. To implement the selected plug group action(s), click on the "Execute Plug

Group Actions" button. The RSM-8R8 Series unit will display a screen which indicates

that a switching operation is in progress, then display the Plug Status screen when the

command is complete. At that time, the Status Screen will list the updated On/Off status

of each plug.

Notes:

• Whenswitchingandrebootoperationsareinitiated,Boot/SequenceDelay

timesanduser-definedPlugPriorityvalueswillbeappliedasdescribedin

Section5.7.

• Ifaswitchingorrebootcommandisdirectedtoaplugthatisalreadyinthe

processofbeingswitchedorrebootedbyapreviouscommand,thenthe

newcommandwillbeplacedinaqueueuntiltheplugisreadytoreceive

additionalcommands.

• WhenthePlugGroupControlScreenisdisplayedbyanaccountthatpermits

AdministratororSuperUsercommandaccess,alluser-definedPlugGroups

willbedisplayed.

• WhenthePlugControlScreenisdisplayedbyanaccountthatpermitsUser

orViewOnlylevelcommands,thescreenwillonlyincludethePlugGroups

thatareallowedbytheaccount.

WTI TSM Series User Manual

Questions and Answers: