To Next Page

To Previous Page

5-55

Basic Configuration

2. MostlyOpen: Access is granted by default, and the only clients denied access,

are those explicitly listed in the Deny list, and as exceptions in the Allow list. To

allow access to all clients except 192.255.255.192 and 168.112.112.05, the Allow

and Deny lists would be defined as follows:

• Allow List:

1. ALL EXCEPT 192.255.255.192, 168.112.112.05

• Deny List:

1. 192.255.255.192, 168.112.112.05

Notes:

• WhendefiningalineintheAlloworDenylistthatincludesseveralIP

addresses,eachindividualaddressisseparatedbyeitheraspace,acomma,

oracommaandaspaceasshowninExample2above.

• Takecarewhenusingthe"ALL"wildcard.WhenALLisincludedintheAllow

list,itshouldalwaysincludeanEXCEPToperatorinordertoallowtheunitto

proceedtotheDenylistanddetermineanyaddressesyouwishtodeny.

5.9.4. Static Route

The Static Route menu allows you to type in Linux routing commands that will be

automatically executed each time that the unit powers up or reboots. In the Text

Interface, the Static Route menu is accessed via the Network Configuration menu. In

the Web Browser Interface, the Static Route menu is accessed via the flyout menus

under the Network Configuration link. Note that parameters defined via this menu will

be applied to both IPv4 and IPv6 communication.

5.9.5. Domain Name Server

The DNS menu is used to select IPv4 or IPv6 format IP addresses for Domain Name

Servers. When web and network addresses are entered, the Domain Name Server

interprets domain names (e.g., www.wti.com), and translates them into IP addresses. In

the Text Interface, the DNS menu is accessed via the Network Configuration menu. In

the Web Browser Interface, the DNS menu is accessed via the flyout menus under the

Network Configuration link. Note that if you don't define at least one DNS server, then IP

addresses must be used, rather than domain names. Note that parameters defined via

this menu will be applied to both IPv4 and IPv6 communication.

The Domain Name Server menu includes a Ping Test feature, that allows you to ping the

IP addresses for each user-defined domain name server in order to check that a valid IP

address has been entered.

Note:InorderforthePingTestfeaturetofunction,yournetworkand/orfirewall

mustbeconfiguredtoallowpingcommands.

WTI TSM Series User Manual

Questions and Answers: