17-2
Command Reference Guide
17.2. Command Summary
Function Command Syntax Command Access Level
Admin. SuperUser User ViewOnly
Display
Port and Plug Status /S [Enter] X X X X
Port Diagnostics /SD[Enter] X X X X
Port Parameters (Who) /W [n][Enter] X X X X
Plug Group Status /SG [Enter] X X X X
Network Status /SN [Enter] X X X X
Network Configuration Summary /RN[Enter] X X X X
IP Alias Status /SA[Enter] X X X X
Alarm Status /AS[alarm][Enter] X
Current Metering /M[Enter] X X X X
View Connection (with Echo) /V<n>[Enter] X X
View Connection (without Echo) /VE<n>[Enter] X X
Help Menu /H [Enter] X X X X
Log Functions /L [Enter] X X
Site ID / Unit Information /J [*] [Enter] X X X X
Control
Exit Command Mode /X [Enter] X X X X
Connect - Local <Remote> /C <n> [n][Enter] X X X
Disconnect Ports /D <n|Nn|*>[Enter] X X
Read Buffer /R <n>[Enter] X X X
Erase Buffer(s) /E <n|*>[Enter] X X X
Boot Plug n /BOOT <n>[,Y] [Enter] X X X
Turn Plug n On /ON <n>[,Y] [Enter] X X X
Turn Plug n Off /OFF <n>[,Y] [Enter] X X X
Default All Plugs /DPL[,Y] [Enter] X X X
Send Parameter File /U [Enter] X
Send SSH Keys /K <n> [Enter] X
Unlock Invalid Access /UL [Enter] X
Outbound Telnet /TELNET <ip> [port] [raw][Enter] X X X
Outbound SSH /SSH <ip> -l <username>[Enter] X X X
Broadcast Mode /broadcast <port list>[Enter] X X
Configuration
System Parameters /F [Enter] X
Serial Port Parameters /P [Enter] X
Plug Parameters /PL <n> [Enter] X
Plug Group Parameters /G [Enter] X
Network Configuration - IPv4 /N [Enter] X
Network Configuration - IPv6 /N6[Enter] X
Ping No Answer Configuration /PNA[Enter] X
Reboot Options /RB [Enter] X
Alarm Configuration /AC [Enter] X
Reboot System /I [Enter] X X
Upgrade Firmware /UF [Enter] X
Copy Port Parameters /CP <z>[Enter] X
Test Network Configuration /TEST [Enter] X
Power control functions are only available on RSM-8R8 Series units.
In Administrator and SuperUser mode, all ports/plugs/plug groups are displayed. In User and ViewOnly mode, the screen will
only display ports/plugs/plug groups allowed by the account. Standard TSM and RSM units do not include switched plugs.
User and ViewOnly level accounts are only allowed to view parameters for the port that was used to access command mode.
User level accounts are only allowed to create a connection to Serial Ports permitted by the account. User level accounts are not
allowed to create Third Party (remote) port connections.
The ",Y" argument can be included to suppress the command confirmation prompt.
In order to invoke this command, Outbound Telnet/SSH and Outbound Service Access must be enabled for your account.
In SuperUser mode, configuration menus can be displayed, but parameters cannot be changed.
Not Available on RSM-8R8 Series units; Ping No Answer parameters are defined via the Reboot Options Menu.
Current and Power Metering capabilities are only available on RSM-8R8-CM Series units.
The User Directory can disable access to Current and Power Metering functions for User and View Level accounts.
To Next Page
Loading...
Need help?
General
