WTI TSM Series - Specifications; Standard TSM Series Units and Standard RSM Series Units

Apx-1
Appendix A. Specifications
A.1. Standard TSM Series Units and Standard RSM Series Units
NetworkInterface: 10/100Base-T Ethernet, RJ45, multi-session Telnet. (TSM-DPE Series Units
include Dual 100Base-T Ethernet Ports.)
RS232PortInterface:
Connectors:
• TSM-8SeriesModels: Eight (8) RJ45 connectors (DTE pinout.)
• TSM-24SeriesModels: Twenty Four (24) RJ45 connectors (DTE pinout.)
• TSM-40SeriesModels: Forty (40) RJ45 connectors (DTE pinout.)
• RSM-8SeriesModels: Eight (8) DB9 connectors (DTE pinout)
• RSM-16SeriesModels: Sixteen (16) DB9 connectors (DTE pinout)
Coding: 7/8 bits, Even, Odd, No Parity, 1, 2 Stop Bits.
FlowControl: XON/XOFF, RTS/CTS, Both, or None.
DataRate: 300 to 115.2K bps (all standard rates).
InactivityTimeout: No activity timeout disconnects port/modem sessions.
Off, 5, 15, 30, 90 minutes.
Memory: Stores Parameters and captured data. 256K per port.
Break: Send Break or Inhibit Break
SiteID: 32 Characters.
PortName: 16 Characters per port.
Usernames&Passwords: 16 characters each (case sensitive.) Up to 128 pairs.
LEDs: On, Ready, DCD, plus Connection Activity for each RS232 Serial Port.
Physical/Environmental:
Power:
• ACModels: IEC-320-C14 Inlet, 100 to 240 VAC, 50/60 Hz, 10 Watts Max.
• DCModels: Terminal Strip, -48 VDC
OperatingTemperature: 32°F to 122°F (0°C to 50°C)
StorageTemperature: -4°F to 128°F (-20°C to 70°C)
Humidity: 10 to 90% RH, Non-Condensing
Venting: Side vents are used to dissipate heat generated within the unit. When mounting the
unit in an equipment rack, make certain to allow adequate
clearance for venting.