WTI TSM Series - Controlling Plug Groups

13-5
Operation via SNMP
13.4.2. Controlling Plug Groups
Note:PowerControlfeaturesarenotpresentonstandardTSMSeriesunits
andstandardRSMseriesunits.Thepowercontrolfunctionsdescribedhereare
onlyavailableonRSM-8R8Seriesunits.
ON, OFF, BOOT, and DEFAULT commands can be issued for plug groups via SNMP.
Plug groups are arranged in a table of 54 rows, one row for each plug group in the
system. Plug Group parameters are described below.
• plugGroupTable::plugGroupName – String indicating the plug groups name
• plugGroupTable::plugGroupAction – Action to be taken on plug group
1 – Mark to turn ON (does not execute)
2 – Mark to turn OFF (does not execute)
3 – Mark to BOOT (does not execute)
4 – Mark to DEFAULT (does not execute)
5 – Mark to turn ON and execute plug group actions
6 - Mark to turn OFF and execute plug group actions
7 - Mark to BOOT and execute plug group actions
8 - Mark to DEFAULT and execute plug group actions
Set plugGroupTable::plugGroupAction to desired action, as specified by values
1-4 above, for each plug group index the action is to be applied to. For the last plug
group you wish to set before executing the commands, use values 5-8 instead, which
will invoke the requested commands all at once.