WTI TSM Series User Manual

5-31
Basic Configuration
• PowerUpDefault: Determines how this plug will react when the "Default All
Plugs" command (/DPL) is invoked, or after power to the unit has been interrupted
and then restored. After the default command is invoked, or power is restored, the
TSM/RSM will automatically switch each plug On or Off as specified by the Power-
Up Default. (Default = On).
Notes:
• Ifyouhaveaccessedcommandmodeusinganaccountthathas
AdministratororSuperUserlevelcommandaccess,thentheDefault
commandwillbeappliedtoallswitchedplugs.
• IfyouhaveaccessedcommandmodeusinganaccountthathasUserlevel
commandaccess,thentheDefaultcommandwillonlybeappliedtothe
plugsallowedbyyouraccount.
• TheDefaultcommandisnotavailabletoViewOnlylevelaccounts.
• BootPriority: When commands are applied to two or more plugs, the Boot
Priority parameter determines the order in which the plugs will be switched On.
The Plug that has been assigned a Boot Priority of "1" will always be switched on
first, followed by the plug that has been assigned the Boot Priority of "2", and so
forth. When you assign a boot priority to any given plug, then all subsequent plugs
will have their priority lowered by one. For more information on the Boot Priority
parameter, please refer to Section 5.7.1. (Default = All plugs prioritized according
to Plug Number)

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English