WTI TSM Series User Manual

7-11
Alarm Configuration
• ResendDelay: Determines how long the TSM/RSM will wait to resend an email
message generated by this alarm, when the initial attempt to send the notification
was unsuccessful. (Default = 60 Minutes)
• NotifyUponClear: When this item is enabled, the TSM/RSM will send additional
notification when the situation that caused the alarm has been corrected. For
example, when Notify Upon Clear is enabled, the TSM/RSM will send initial
notification when it detects lost communication with the a WTI device connected
to one of the TSM/RSM Serial Ports, and then send a second notification when it
determines that communication has been restored. (Default = On)
• EmailMessage: Enables/Disables email notification for this alarm. (Default = On)
• Address1,2,and3: These parameters are used to select which of the three email
addresses defined via the "Email Messages" menu (see Section 5.9.11) will receive
the email alarm notification messages generated by this alarm. The Address
parameters can be used to select one, or any combination of the addresses defined
via the Email Messages menu. (Default = All On)
Note:IfEmailaddresseshavebeenpreviouslydefined,thenthetextunderthe
parameterswilllistthecurrent,userdefinedemailaddresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
field for all email notification messages generated by this alarm. (Default = "Alarm:
Lost Comm with Unit")

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English