WTI TSM Series User Manual

9-9
Operation
If the buffer contains data, the TSM/RSM will display a prompt that offers the following
options:
• DisplayOneScreen: To send data one screen at a time, press [Enter]. Each time
[Enter] is pressed, the next screen is sent.
• DisplayAllData: To send all data currently stored in the buffer, type 1 and
press [Enter].
• EraseDataonScreen: To erase the data currently displayed on-screen,
type 2 and press [Enter].
• EraseallData: To erase all data currently stored in the buffer, type 3 and
press [Enter].
• Exit: To exit from Read Buffer mode, press [Esc].
Note:Onlyoneusercanreadfromaportbufferatatime.Ifaseconduser
attemptstoreadfromaportthatisalreadybeingread,anerrormessagewillbe
sent.
To clear data from any port buffer (with or without reading it first), access command
mode via the text interface, using an account and port that permit Administrator,
SuperUser or User level commands, then issue the /E (Erase Buffer) command using
the following format:
/E xx [Enter]
Where xx is the number of the port buffer to be cleared.
Notes:
• The/Ecommandcannoterasedatafromaportbufferthatiscurrentlybeing
readbyanotherport.
• The/EcommandisnotavailabletoViewOnlylevelaccounts.
• BuffereddatacanonlybeerasedviatheTextInterface.TheWebBrowser
Interfacedoesnotoffertheoptiontoerasebuffereddata.

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English