WTI TSM Series User Manual

10-3
Telnet & SSH Functions
4. OFF-BreakonRawDisconnect: When the Direct Connect option has been
enabled as described in Steps 2 or 3 above, this option can be used to configure
the TSM/RSM to send a break character whenever a Raw Socket connection to this
port is terminated. As described below, the Break on Raw Disconnect option will
work when the password feature is either enabled or disabled as described below:
a) PasswordDisabled: To employ the Break on Raw Disconnect option with the
Direct Connect password disabled, proceed as follows:
i. Access the Serial Port configuration menu for the desired TSM/RSM
serial port, and then use the Direct Connect option to select the "On - No
Password" option. After "On - No Password" is selected, the menu will
return to the Serial Port configuration screen.
ii. Use the Direct Connect option to select the "Break on Raw Disconnect"
parameter. After "Break on Disconnect" is selected, the menu will return
to the Direct Connect configuration screen. Note that at this point, the
prompt for the "Break on Disconnect" option will read "On - Break on
Disconnect", indicating that both the Direct Connect feature and the Break
on Disconnect feature are enabled.
a) PasswordEnabled: To employ the Break on Raw Disconnect option with the
Direct Connect password enabled, proceed as follows:
i. Access the Serial Port configuration menu for the desired TSM/RSM serial
port, and then use the Direct Connect option to select the "On - Password"
option. After "On - Password" is selected, the menu will return to the Serial
Port configuration screen.
ii. Use the Direct Connect option to select the "Break on Raw Disconnect"
parameter. After "Break on Disconnect" is selected, the menu will return
to the Direct Connect configuration screen. Note that at this point, the
prompt for the "Break on Disconnect" option will read "On - Break on
Disconnect", indicating that both the Direct Connect feature and the Break
on Disconnect feature are enabled.
Notes:
• Ifyouintendtocreate"RawSocket"connectionstoTSM/RSMserialports,
thenthe"RawSocketAccess"featuremustalsobeenabledattheNetwork
Port,asdescribedinSection5.9.2.
• IfyouintendtouseSSHtoestablishdirectconnectionstotheTSM/RSM,the
"DirectConnectON-PASSWORDoptionmustbeselected.
• IfAdministratorlevelcommandsaredisabledattheNetworkPort,then
accountsthatpermitAdministratorlevelcommandswillnotbeabletoinitiate
aDirectConnection.
• IfAdministratorlevelcommandsareenabledattheNetworkPort,then
accountswithAdministratorlevelaccessandaccountswithoutAdministrator
levelaccesswillbothbeallowedtoestablishDirectConnections.
• Ifyouruseraccountdoesnotpermitaccesstothetargetport,theconnection
willberefused.

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English