5-17
Basic Configuration
• IPSMode: This parameter sets up the TSM/RSM for use with command scripts
that were written for WTI's IPS Series Remote Reboot Switches. When the IPS
Mode is enabled, the "IPS" command prompt will be displayed in the Text Mode,
User Accounts will not allow definition of a Username, and only the "password"
prompt will be displayed when logging into the unit (IPS Mode units will not display
a "username" prompt.) (Default = Off)
• The "IPS" command prompt will be displayed in the Text Mode.
• Providing that no Administrator level user accounts are defined, the TSM/RSM
will not display the username or password prompts upon login to
command mode.
• If one or more Administrator level user accounts have been defined, then the
TSM/RSM will only display the password prompt upon login to command mode.
If all Administrator level user accounts (aside from the default "super" account)
are deleted, then the TSM/RSM will return to the status where no username or
password prompts are displayed upon login to command mode.
• SinglePlugBootDelayEnable: (RSM-8R8 Series Units Only) When enabled, the
currently defined Boot/Sequence Delay value will be applied when a single plug
is rebooted, and to the final plug in a Plug Group when an entire Plug Group is
rebooted. This allows you to specify the "Off Time" that wil be used when a single
plug or the last plug in a Plug Group is rebooted. For more information on the
Boot/Sequence Delay parameter, please refer to Section 5.7. (Default = Off)
To Next Page
Loading...
Need help?
General
