WTI TSM Series - Page 86

5-57
Basic Configuration
• SNMPv3UserName: Sets the User Name for SNMPv3. Note that this option is
not available when the Version parameter is set to V1/V2. (Default = undefined)
• SNMPv3Password: Sets the password for SNMPv3. Note that this option is not
available when the Version parameter is set to V1/V2. (Default = undefined)
• SNMPv3PasswordConfirm: This prompt is used to confirm the SNMPv3
password that was entered at the prompt above. Note that this option is not
available when the Version parameter is set to V1/V2. (Default = undefined)
• AuthenticationProtocol: This parameter determines which authentication protocol
will be used. The TSM/RSM supports both MD5 and SHA1 authentication.
(Default = MD5)
Notes:
• TheAuthenticationProtocolthatisselectedfortheTSM/RSMmustmatchthe
protocolthatyourSNMPclientwillusewhenqueryingtheTSM/RSMunit.
• TheAuthenticationProtocoloptionisnotavailablewhentheVersion
parameterissettoV1/V2
• SNMPContact: (Default = undefined)
• SNMPLocation: (Default = undefined)
• ReadOnlyCommunity: Note that this parameter is not available when the SNMP
Version is set to V3. (Default = Public)
• Read/WriteCommunity: Note that this parameter is not available when the SNMP
Version is set to V3. (Default = Public)