Yamaha A3000 - Copy

COMMAND Pages
102
Chapter 4 PLAY Mode
COPY
Copies all program data from selected program into destination program, resulting in two copies of the same
program.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >COPY.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
Use this page to copy (replicate) a program. The A3000 copies all data from the selected
memory-resident program into the destination memory-resident program. Following
the copy, the two programs will have identical data but different program numbers.
Knob 1 Change Page >COPY
• Turn the knob to change to a different command page.
• Push the knob to execute the copy. The A3000 returns a confirmation screen. Push
Knob 5 (>YES) to complete the copy, or Knob 4 (>NO) to cancel.
Knobs 2, 3 Program = 001,...,128
Turn either knob to select the program that you want to copy.
Knobs 4, 5 To = 001,...,128
Turn either knob to select the destination program number.