136
Chapter 4 PLAY Mode
CONTROL Function
CONTROL Function
The PLAY-mode CONTROL function sets up the program’s controller handling.
CONTROL - PgmCtl1 (Program Controller Setup 1)
Sets the program’s controller usage.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select PgmCtl1.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ - ✔ --
You use this page together with page PgmCtl2 to set up the controller matrix that
determines how selected MIDI controllers operate on the program’s playback. The ma-
trix selects up to four controllers, and assigns to each of these a specific function and
operating range. A conceptual illustration of the matrix is shown below.
The controller settings that you make here operate in response to control-change mes-
sages received over the Basic Receive Channel. (☞305)
Matrix#
1
2
3
4
Device Function Type Range
Matrix No.
Selects the controlled
parameter.
Sets the maximum
control range.
Selects a controller. Determines how the A3000 converts
the received controller values.
You use the PgmCtl1 page to set the Device and Function values only. Use page PgmCtl2
(☞139) to set the Type and Range values.
To Next Page
Loading...
Need help?
General
