223
Chapter 6 RECORDING Mode
Chapter 6
RECORD Function
RECORD Function
You use the RECORD function to record a new sample.
Important
Before beginning to record, you must first use the other RECORDING-mode functions
to set up the recording environment.
RECORD - Record
Records a sample.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action -----
Push action ✔✔ - ✔✔
Use this function to record one or more samples.
• The function begins by displaying the “initial recording page” shown above — the
first of several pages that appear during recording. (If you have set the Sample value
in the Target page (☞230) to Replace, then >RETRY will appear in place of >GO
above Knob 5.)
• The value shown above Knob 2 indicates the maximum length (in seconds) currently
available for your recording.
Knob 1 Select P/S
Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 >ALLDEL
If you are in the process of recording a series of samples, you can use this command to
delete all samples that you have just finished recording. This command is available only
if you are using serial recording (only if the Sample value in the Target page (☞230) is
set to New+), and only if you have already completed at least one recording in the
series.
To Next Page
Loading...
Need help?
General
