259
Chapter 7 DISK Mode
Chapter 7
PROGRAM Function
PROGRAM Function
You use the PROGRAM function to load one or all programs from a floppy disk or SCSI
disk volume into the A3000 main memory. Before using this function, you must select
the source disk or volume using the DISK or VOLUME function.
• If loading from a floppy disk, you must first insert the floppy disk into the A3000
floppy drive, and then select the disk at the DISK function. (☞268)
• If loading from a SCSI disk, you must first select the disk (partition) and volume
containing the program(s) you want to load. (☞268, 266)
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled “Disks and Volumes” in Chapter 3. (☞81)
FYI
Before you can load programs, you must first save them to disk. You can save your
programs to disk using the PLAY | PROGRAM function. (☞110)
PROGRAM - PgmLoad (Load Program(s))
Loads one or all programs from disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action - ✔ ---
Push action ✔ --✔✔
Use this page to select and load one or all programs, together with all samples used by
these programs.
FYI
If you want to load a program from disk into a different program number in memory
(for example, Program 001 from disk into Program 003 in memory), you should first
select the disk-side program at this page, and then press the COMMAND key and use
Knob 3 or 4 to select the program number for the destination program. (☞249)
To Next Page
Loading...
Need help?
General
