COMMAND Pages
149
Chapter 5 EDIT Mode
Chapter 5
REVERT
Overwrites memory-resident sample with the disk version of the sample.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >REVERT.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔ ----
Push action ✔ ----
This operation reloads the selected sample or sample bank from disk into memory,
canceling any new editing changes that you have made. This operation is available only
if you have already saved the object to disk.
You use this operation to cancel “errors” that you make when editing or re-recording a
sample. Assume, for example, that you record a sample, immediately save the results to
disk (as you should), and then start to edit. If you now make a significant error during
editing, you can use the REVERT command to restore the sample to its initial state. You
can then begin editing all over again.
Important
• This operation is available only if you have already saved your data to disk. Remem-
ber to save important data to disk before you make significant editing changes.
• This operation is not available with imported samples.
Knob 1 Change Page >REVERT
• Turn the knob to change to a different command page.
• Push the knob to execute the reversion. The A3000 returns a confirmation screen.
Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
To Next Page
Loading...
Need help?
General
