COMMAND Pages
108
Chapter 4 PLAY Mode
SMPDUMP (Sample Dump)
Transmits a bulk dump of the selected sample.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >SMPDUMP.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ - ✔
Push action ✔ ----
Use this page to dump a memory-resident sample or sample bank to an external MIDI
device. The dump operation transmits all of the sample’s data (or parameter data only;
see below) to the external device.
Important
Before you can transmit or receive a sample dump, you must set matching device-number
values at the A3000 and the external device. (☞310)
Knob 1 Change Page >SMPDUMP
• Turn the knob to change to a different command page.
• Push the knob to execute the sample dump. The A3000 returns a confirmation screen.
Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
Knobs 2, 3
Sample = sample name
• Turn either knob to select the sample or sample bank that you want to dump.
• If you select a sample bank: a [B] appears before the sample-bank name, and the
operation name above Knob 5 changes from Format to withRelated.
Knob 5 • Format = norm, param, SDS#1,...,#1025
• withRelated = off,on
The selection here varies according to whether you are dumping a sample or a sample
bank.
• If you are dumping a sample, use the Format setting to select the dump format. Avail-
able formats are as follows.
norm Transmit all data (wave and parameter) in A3000 format.
param Transmit parameter data only, in A3000 format.
To Next Page
Loading...
Need help?
General
